Top 9 Ge Duck

iPower is the leading manufacturer of grow light systems; supplying gardeners, worldwide, for over a decade. We use the transformative power of light to make gardening more efficient and productive. In addition to HPS/MH and Ceramic MH technology, we offer digital ballasts, fluorescent, and LED lighting systems. From hobbyist to commercial applications, we offer a broad spectrum of gardening tools and equipment in hydroponics, irrigation, climate control, and structures to help your garden thrive.

iPower Ventilation Ducting is made from high quality aluminum to provide flexibility and protect against breaking during installation. Not only does the duct act as in intake and exhaust piping for active-cooled fixtures and reflectors, but also stores and dissipates heat at a steady rate, which reduces room temperature fluctuations.

Benefits of iPower Ducting:

1. This 4-inch ducting fits any standard 4-inch inline fan.
2. 3-layer thickness: Aluminum Foil + PET + Aluminum Foil.
3. Helically shaped and internally crimped galvanized steel strip.
4. Interlocking steel strips to form an air tight and leak proof system.
5. Each ducting unit includes a pair of metal clamps made from stainless steel.
6. This air duct is easy to cut using a pair of metal snips or a standard wire cutter.
7. This ducting is easy to bend to install in hard to reach spaces such as grow rooms, attics, crawl spaces, etc.
8. This ducting is made with aluminum reinforced with a spiral-wire, designed to prevent the ducting from unraveling when cut into smaller pieces.
9. Typical applications for ventilation ducting include: dryer room vents, A/C or Heater ducting, grow room ventilation and other indoor gardening applications.
10. 12-month manufacturer warranty.

Product Description

This is a genuine replacement part. The model number and name for the following item is: General Electric WJ85X10041 Air Filter.

From the Manufacturer

This is a genuine replacement part. The model number and name for the following item is: General Electric WJ85X10041 Air Filter

The MV-90 is designed for when the vent path takes a 90 degree turn, such as down through the floor, up through the ceiling, or off to the side. -The MV-90 can handle offsets up to 3 inches from center to center. The more accurately you line up the MV-90 with the vent on the back of your dryer, the better the vent path and the further back you can locate your dryer. Normally, the MV-90 requires 5 1/2 inches of clearance behind the dryer. If an obstruction necessitates you locate the MV-90 at the maximum 3 inch offset, then your dryer will need to sit out an additional 3 inches to allow for a bend radius in the transition duct. -Close vent offsets between dryer and wall vent located on same wall as dryer (Offsets between 6-9 inches): The MV-90 can be coupled directly to a standard 4 inch diameter, adjustable, 90 degree elbow which creates a 9 inch offset. See photo below. If your same wall offset is 6 inches, you can use the MV-90 and an elbow, taking advantage of its ability to handle misalignment up to 3 inches. -Same wall offsets greater than 9 inches: Simply mount the MV-90 directly behind your dryer, plug the 90 degree elbow into the wall vent, and measure for the required length of rigid metal pipe between them. Make sure to measure from where the pipe will stop on the MV-90 to the stop on the male end of the rigid metal pipe. -Close vent offsets between dryer and wall vent located on same wall as dryer (Offsets between 0-3 inches): If your same wall offset is between 0 and 3 inches, then the MV-180 is the product for you.

It Fits For Most People, No Matter You Are A Adult Or Youth, Man Or Woman, It Can Be A Great Choice.